I looked at doing this for a project. What really matters is
that once the tirac is on, the gate goes low before the next
zero crossing if you want it to go off. This can be done by
setting up the timer to interrupt you whenever the output
needs to change state. In the ISR to handle the timer interrupt,
you would toggle the output and immediately schedual the next event.

Like you, I wanted to use the timer to keep track of other things.
One thing I found was an I2C real time clock - Phillips PCF8593.
You could set the RTC to give you an alarm interrupt, freeing up
the timer. This was optimal for me because some of the delay times
were very long. The application might want to wait an hour and then
dim the light for 5 minutes.

I drove the gate with a MOC3033 triac optoisolator. You can
built a zero crossing detector from a comparitor to synchronize
the the gate transitions with the zero crossings.

If you want the chopping to be pasive to your PIC, why don't you
use two PICs?

Regards,

Chris Atkins

----------
From:   Aaron J. Miller
Sent:   Thursday, March 27, 1997 2:15 PM
To:     PICLIST@MITVMA.MIT.EDU
Subject:        Suggestions for AC chopper?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Hello all,

This question is only marginally related to pic's since I am going to use
a 16C84 to control the chopper, but there seem to be quite a few bright
people out there who may be able to help...

I am trying to make an incandescent lamp dimmer from a 16C84 and planned
on doing a simple waveform chop using a triac.  I realized, however, that
since the pic is going to be doing a bunch of other time sensitive stuff
that I don't have the processor time to manually sense the zero and chop
the wave using the pic.

So, is there any easy method to passively (from the pic's point of view)
chop the AC wave?  i.e. use 8 I/O pins to a D-A to give a reference to the
chopper circuit and have it do the rest?  That way I can just output the
light level to the pins and it would stay put leaving the rest of the
processor available?

Thanks for any help,
aaron

-------------------------------------------------------------------------------
-     Aaron J. Miller           Email: millera@stanford.edu
-     Physics Graduate Student  Web  : http://www.stanford.edu/~millera
-     Stanford University       Phone: (415) 372-5575 (until 4/12/97)
-------------------------------------------------------------------------------