At 04:58 PM 3/19/97 +0000, you wrote:
>andy,
>
>"In the File | Project Info dialog, you can select the assembler you are
>using.  NOTE:  You must put the executable file for it in your PDE
>directory!"
>
>i can't select mpasm in the project info box! i've put the mpasm.exe
>in the pde directory. all the entries in the project info box, apart
>from the pasm, are blanked out.
>
>do i need to do something else?

INSTALL MPASM into the same dir as PDE.

Sorry.

ALso, make sure you are running SPASM v 4.7 (go to DOS and type SPASM and
it'll tell you.  Same for SPEP).

Andy

==================================================================
Andy Kunz - Montana Design - 409 S 6th St - Phillipsburg, NJ 08865
          Hardware & Software for Industry & R/C Hobbies
        "Go fast, turn right, and keep the wet side down!"
==================================================================