thanks Andy - i'm installing PDE 2.1 now - when you say i can specify
which assembler i'm using you mean i can use the mpasm assembler and
then simulate using PDE right?

that would save me a *lot* of trouble!

nish

Andy Kunz wrote:
>
> >when i try and run my code (the c74 code) it does not seem to run
> >correctly - or at least i don't see the correct memory map as i do when
> >i use PDE in windows.
>
> Sounds like you are using the wrong version of PDE.  Download version 2.10
> or later from parallaxinc.com.
>
> >any tips?
> >
> >the reason i'm not using pde to run code is now i've got lots of code
> >for the mpasm compiler - so i'm using mpasm to compile this. so i can't
> >use pde to run the code and i want to use the dos simulator.
>
> In the File | Project Info dialog, you can select the assembler you are
> using.  NOTE:  You must put the executable file for it in your PDE directory!
>
> Andy
>
> ==================================================================
> Andy Kunz - Montana Design - 409 S 6th St - Phillipsburg, NJ 08865
>           Hardware & Software for Industry & R/C Hobbies
>         "Go fast, turn right, and keep the wet side down!"
> ==================================================================