Okay, this is probably a stupid question, but I was
wondering how to set the config bits (for a 16c84 --
doesn't matter which, just the general idea).

In the Microchip data book, it says that they are
set via a 'special mode' during programming.

Does this mean you set them manually while using a
programmer?  Or can/do you set them in the source
code?

(I know this is MUCH easier than it seems...)

Paul Bennett
pbennett@kilby.elee.calpoly.edu

Robotic Building Priciples:
1)  If it isn't nailed down, it's a potential robot part
2)  If it is nailed down, find a prybar, then refer to 1