Last week I asked the question if anybody knew of an add on signal level
translator for the Picmaster emulator. I didn't receive any replies which
prompts me to ask "Does anybody run on 3 volts?" If you do run on 3
volts how do you emulate during debug? I understand that if the total
system could be ran at 5 volts then it wouldn't require a translation,
one would turn up the voltage, emulate till "all" bugs are gone, then
set the voltage back down to 3 and hope the additional prop delays don't
cause any problems.
I cann't do that because of the analog circuits in the system.
Maybe the questions to ask are"
 "Does anybody know of an emulator that runs at 3/5 volts ?"
 "Is there a market for an emulator signal level translator?"
 "Am I the first in the history of mankind to face this problem?"

 Harris Corporation does not make this type of equipment.

regards

Jerry English