On 15 Dec 96 at 23:33, Stephen H Alsop wrote:
 >
> I know this will probably be a stupid question, but, how do you change the
> data in the 'w' register when using MPLAB in software simulation mode.

> I can change any ram/file address using the modify window (enter the
> address then the value and click on Write) but when I try to change the w
> register it remains unchanged (entering 'w' as the address, etc).  I have
> tried what I think are all combinations without success.
>
> Thanks

My  answer:
>
>How about  Debug-Execute-Execute an opcode- MOVLW xxx ?

Jan van der Watt wrote:

> Funny, I just double-click on 'W' in the Special Function Registers Window,
> enter the new value for W and VOILA !
>
You are right ! It was only necessary to point with the mouse BEFORE
the "w" on the window, close to the border !
On the "longer" names of the registers it is easier and faster,as you can
click everywere BEFORE the last letter of the name, but the "W" register
has only a place where to click !
Thank you....
Bruno
=====================================
Bruno Rodeghiero I3RGH
36061 Bassano del Grappa (VI) - ITALY
mailto:brurodeg@mbox.vol.it
=====================================