NEIL GANDLER wrote:
>
> Microchip just sent me 2 samples of a windowsed version of the PIC16C74.
> I requested the 16C74 yet they sent 16C74A which have the Brown-out
> detector circuit on-chip. I am currently using a PIC-1A programmer from ITU.
> These new PICs seem to program properely. Upon verification by the
> ITU software, the code verrifies to be correct. But when placing
> them in circuit, they simply do not work at all. They seem to be
> stuck in a permanent reset mode. Even disabling the watchdog timer
> doesn't help. I did note that the configuration word of these two PICS
> are different. I did take this into consideration. I made sure to keep the
> Brown-out reset module disabled. I also did trials experimenting with PWRTE
> either enabled or disabled. I made sure I was writing the proper configuration
> word, by checking the actual hex word, before the itu software writes
> the configuration. Still no luck.
>
> Neil GandlerI use a PICSTART16-C and the PIC16C74A (UV version) is working
 fine!
Make sure your target system hardware is correct (oscillator HS, WDT disabled)
and that porta is configured for digital signals if you need then (default is
 anolog)!


Good luck!