At 08:10 AM 2/12/96 -0500, you wrote:
>     You got a stimulus file to work? The setup seems easy enough, but my
>     watch window just showed zeros being read in.  I sent a fax to tech
>     support but never heard back. What steps did you take to get it to
>     work?
>
>     Brian
>     bleger@harris.com

Are we talking about good, old MPSIM which runs on DOS? I frequently fall
back on it when MPLAB gets too confusing. What did your sti file look like?
I haven't had any problems with it. In fact, I debug all my programs on it.
I have yet to figure out how to do most of the stuff in MPLAB.

As far as the zeros in the watch window are concerned, I remember someting
about the port registers not being updated properly in the watch window. SO
I would single step through your program and see if the values get to your
program ok. The watch window may be the one at fault. If that is the case,
then there is a way around it.. one which I seem to have trouble
recollecting just now.

Regards

Prashant
--------------------------------+---------------------------------
  Prashant Bhandary             | Tel:  +61-2-9662 5299
  Spatial Information Solutions | Fax:  +61-2-9662 5348
  Roads and Traffic Authority   | Email: prashb@rta.nsw.gov.au
  Rosebery NSW 2018, AUSTRALIA  | "2b|!2b" - William Shakespeare
--------------------------------+---------------------------------