On Fri, 23 Aug 1996, Philip Lalone wrote:

>         Is it possible to control a stepper motor from a PIC16c84, how
> would I go about doing this?
>
>                                                 Philip Lalone
>                                                 plalone@alphax.com
>                                                 Alpha-X Development
>

Philip,

The short answer is yes. I did it by using a simple look-up table for the
coils and then had counter to hold the position information. Then by
cycling through (left or right) the stepper can be controlled very easily.

I hope this has been of help.

Rich


Department of Applied Physics, University of Hull, HU6 7RX
Tel 01482 465135  Fax 01482 465606 // E-mail R.J.Smith@apphys.hull.ac.uk