At 07:42 AM 5/20/96 -0500, you wrote:
>>        I am searching for an RF transmitter/Receiver IC pair for use
>>as a low baud rate digital wireless communication link for a home automation
>>device. Such an ideal IC pair would only require a few external RF
>Please repost your results?! I'm also trying to figure this stuff out.
>

I've lost the original post for this but this may help.
  I've just finished a 900MHz cordless phone design that uses the 16C57 for
the control processor.  The project called for modem commands to be sent and
received.  The baseband (read audio frequency) processor that I used is the
AKM2358E from Asahi Kasei.  It has a compandor, scrambler, volume controls
and a MSK 2400 baud modem built in.  Interface to the modem is improved over
the older 2353 with the addition of a receive buffer.  It should work with
just about any radio set (including walkie talkies or key chain radios).
Unfortunately I do not know where you can obtain one but if you are
interested I can do some research.

Bryan