I have RA4 on a 4.7K pullup.  When I drive the pin high I only get a voltage
of 2 volts maybe 2.1.  4.7K!!!  Anyway It hangs around .68mV when I am 
not driving it low.  I really need help with this.  I fall below ttl 
level from time to time and its killing me.  It works fine if I put a 
680Ohm pullup on it but then my lower voltage is horrendus(sp).  I know 
about the screwed up tristate reg on it and I only move an image of RA 
into the ra reg(not the tristate I leave it alone).
Help please....
later
        John

_____________________________________________________________________________
John Johnson                   |If it's not OS/2.|johnsonj@ccwf.cc.utexas.edu
                               |It's crap!       |johnsonj@ghostwheel.bga.com
OOOO SSSS    /2222  2222    11 |                 |
O  O S      /    2     2     1 |"We need breath- |"Bite me." Tom Servo
O  O SSSS  /  2222  2222     1 |-ing room!"      |
O  O    S /   2     2    ..  1 |     Bill Gates  |"I want to decide who lives
OOOO SSSS/    2222  2222 .. 111|                 |and who dies" Crow T. Robot
-----------------------------------------------------------------------------