[Menu]>[Manufacturing of Original PCB]>[Implement of the PBC making]>[Ultraviolet ray exposure equipment]>[Equipment explanation]

Structure explanation
of the ultraviolet ray exposure equipment


The structure of the ultraviolet ray exposure equipment is explained below.

It is letting the fluorescence light inside the chassis.
Also, it is arranging the circuit part in the top.
Because the manufacture is easy, the material of the chassis is using the aluminum board with the 0.3-mm thickness.
There was a size as follows.

The length	:	400 mm (The length of the fluorescence light : Considering 345 mm)
The depth	:	170 mm (The width of the clamp equipment : Considering 170 mm)
The height	:	100 mm (I consider the curve of the reflection board but it is suitable)

Because it is using AC100 V for the circuit, I put the cover so as not to touch and to be shocked.
Because the circuit part generates the heat little, the cover is using the aluminum punching board(1.5-mm thickness) that the hole with the 3-mm diameter was open.
It distorts the depth to 172 mm(2 mm are wider than the chassis).
Then, it attaches the wooden square lumber to the place to want to distort and it bends it with the hammer.
( It is quite terrible.It thinks that it is easy when the acquaintance has the blacksmith person. )
There was a size as follows.

The length	:	400 mm
The depth	:	172 mm
The height	:	150 mm (By considering the height of the part, the 50-mm space made the top of the chassis be formed.)

It is installing the L-shaped aluminum angle stick in the cover side which fell by 50 mm from the top of the cover to secure the 50-mm space(because the cover and the part don't touch) when putting on the cover on the chassis.

It is installing the 10-mm thickness wood board in both sides of the chassis.
It is installing the side cover to secure the 30-mm space under the equipment(it puts the clamp equipment) and to reinforce the chassis.
Because the chassis itself curves outside with the spring of the fluorescence light socket because the chassis is the aluminum board with the 0.3-mm thickness, it is the reinforcement.
There was a size as follows.

The thickness	:	10 mm
The depth	:	172 mm
The height	:	180 mm